Orange Pi Lite SBC (Linux/Octoprint)

Product Description

For Octoprint etc

http://www.orangepi.org/orangepilite/

(SDCard not included, needs a genuine class 10 card)

Note for the Octoprint use case we usually stock a few voltage step down modules here for powering these boards or similar from a 3D Printers 12-24VDC supply

Specification (From the manufacturer):

• CPU: H3 Quad-core Cortex-A7 H.265/HEVC 4K
• GPU: Mali400MP2 GPU @600MHz
  • Supports OpenGL ES 2.0
• Memory (SDRAM): 512MB DDR3 (shared with GPU)
• Onboard Storage: TF card (Max. 32GB) / MMC card slot
• Wifi Antenna
• Video Input: A CSI input connector Camera:
  • Supports 8-bit YUV422 CMOS sensor interface
  • Supports CCIR656 protocol for NTSC and PAL
  • Supports SM pixel camera sensor
  • Supports video capture solution up to 1080p@30fps
• Audio Input: MIC
• Video Outputs:
  • Supports HDMI output with HDCP
  • Supports HDMI CEC
  • Supports HDMI 30 function
• Audio Output: HDMI
• Power Source:
  • DC input (USB OTG input don’t supply power)
• USB 2.0 Ports: Two USB 2.0 HOST, one USB 2.0 OTG
• Buttons: Power button
• Low-level peripherals: 40 Pins Header,compatible with Raspberry Pi B+
• GPIO(1×3) pin: UART, ground
• LED: Power led & Status led
• Key: POWER

Supported OS

• Android
• Lubuntu
• Debian
• Raspbian Image

Interface definition

• Product size: 69mm × 48mm
• Weight: 60g